ECS Stage I Fuel System Instructions The ECS Stage I fuel System is designed for late model Corvettes not exceeding 750 RWHP. The System comes with a
With a 90 degree drill, or a long drill extention, Use the supplied 1 ¾ hole saw, drill tank as shown being sure to de burr tank and clean any residu
Suspend backer plate freely in tank. Insert fuel puck up with fuel sock being careful not to hit backer plate. Slide backer plate over fuel pick
Reinsert wire tool into backer plate through return opening or one of the screw holes to support backer plate holding it against the back of the tank.
It is your responsibility to make sure that your connections are correct and leak free. If you are unsure of how to properly install AN fittings
The Fuel Line adapter will snap in place between the factory fuel pump outlet and the factory fuel feed line as shown below. With a second lengt
Wiring the ECS fuel system is very simple. Wire the provided 3 wire relay as follows: Fused Power to 12v power on back of alternator. Fuel Pump powe
Kommentare zu diesen Handbüchern